Phytochemical Analysis on Moringa Olrifera and Azadrichta Indica Leaves

PHYTOCHEMICAL ANALYSIS ON MORINGA OLRIFERA AND AZADRICHTA INDICA LEAVES

ABSTRACT
Studies were conducted to determine the phytochemicasl present in moringa olrifera and Azadrichta indica leaves. Leaves for this work were washed, room dried ground to powder. The ground leave for both sample were soaked in four different solvent; Ethanol, n-Hexane, Ethyl acetate and water for 24 hours. After the contact elapsed the solvent were filtered to recover the extract. [Read more…]

The Effect Of Temperature On Hydrolysis of Cellulose (Saw-Dust)

THE EFFECT OF TEMPERATURE ON HYDROLYSIS OF CELLULOSE (SAW-DUST)

ABSTRACT
The effect of concentration of hydrochloric acid on hydrolysis of cellulose (saw-dust) to glucose was studied on this research project and the steps obtained to achieve this project involved treatment of saw-dust (cellulose) with different concentrations of the acid at constant temperature of 80°𝐶 (350k) for 30mins. [Read more…]

Comparative Analysis of Coal, Fuel Oil and Natural Gas for Cement Production

COMPARATIVE ANALYSIS OF COAL, FUEL OIL AND NATURAL GAS FOR CEMENT PRODUCTION

ABSTRACT
This study is a comparative analysis of the use of coal, fuel oil and natural gas for cement production noting their physical and chemical properties, cost and availability, impact on the environment and human health. Out of the seven cement manufacturing industries in Nigeria, three industries use these fuels were selected for the study. The industries are NigerCem –Ebonyi state, Dangote cement –Benue state and UniCem -Cross river state. [Read more…]

Construction of a Fluidzed Bed Reactor

CONSTRUCTION OF A FLUIDZED BED REACTOR

ABSTRACT

The project is the construction of fluidised bed reactor. After a detailed research mild steel was chosen as the material of construction based on its inherent properties. The construction process entitles the marketing out of the sheet to the specified dimensions. This was followed by center punching and cutting. The sheets are then joined together after rolling by welding. [Read more…]

Construction of a Standard Drawing Desk

CONSTRUCTION OF A STANDARD DRAWING DESK

ABSTRACT

This project is a fabrication of a standard drawing writing desk using the cheapest, effective and most readily available materials. Method of maintenance and services were also taken into consideration.The functional aspect of the equipment was also given adequate consideration in the project work. Also take into consideration the reliability, portability and general values, appearance of the equipment. [Read more…]